Solo Systems, Inc.
4001 Industrial Street * Rowlett, TX 75088
800.259.5570 * 972.475.5569
WIDE FORMAT
S900 series
S912-150-154 seen in background.
Great for Wide Format Blown Film lines
* One side of the web is treated.   * Best option for lumber wraps or carpet products, etc.
QUALITY

All Solo Systems' brand corona treaters are built to last.  With corrosion resistant
materials, stainless steel hardware and careful construction, you can expect years of
trouble-free corona treating, minimal maintenance and maximum productivity from
your line.
 

PERFORMANCE FEATURES

S900 have been formatted for very wide web treating.  Though the S900 also comes
in shorter versions, it is really a power horse for larger webs.  For additional
information on short versus long versions of the S900, check out this
page.

VENTILATION

Film entry and exit slots are kept narrow by counterweighted, swing away panels.  
These panels allow start-up knots to pass through the station and then swing back to
position for correct air infiltration.  An exhaust duct(s) is provided to connect to your
plant exhaust system.

SIMPLE INSTALLATION

S900 treaters are completely pre-wired internally with ready hookups for air and
electric.  Mounting brackets are pre-drilled for your installation site or portable
equipment cart.  Portable equipment carts are also available for purchase to fit your
new or existing treater.  

Our S900 series treaters come in sizes from a 6" diameter roll to a 24" diameter
roll.  This system treats one side of the web. Station can be made for either top-side
treating only or bottom-side treating only.

*Important: Please specify top-side or bottom-side treating at time of order
placement.  

Standard Features:

  1.    Electrodes adjustable in 1/2" or 1" increments
  2.    Electrodes matched to your power supply
  3.    Enclosed electrical and pneumatic assemblies
  4.    Stainless steel hardware
  5.    Sealed bearings
  6.    Safety/door interlocks
  7.    Zero speed switch
  8.    Pre-wired internally
  9.    Exhaust duct built in
  10.    Mounting brackets pre-drilled





Optional features for S900 series treaters:
  •    Nip rolls
  •    Drive assembly
  •    Input and output idler rolls, if needed.
  •    E-3 Epoxy treater roll coating, ceramic, glass or silicone sleeve
  •    Adjustable or fixed electrode segments.
Roll slot for easy
removal of treater roll.
E-3 Epoxy roll coating
Fully enclosed treat process
Two exhaust ducts to remove
ozone and limit noise
Solo Systems' treaters are easy to order.  
We help you look at alternatives, plan for variables,
and specify a cost-effective treater for your line -
often in a single phone call!

Contact us today with your questions.
Hosting by Aabaco Web Hosting
Copyright 2017 Solo Systems, Inc. All rights reserved.
Back of S912-144-148.